On-line AirScoot Assembly Manual - Safety Guidelines

DO NOT ATTEMPT TO OPERATE THE AIRSCOOT HOBBY MODEL WITHOUT FIRST READING AND UNDERSTANDING THE SAFETY GUIDELINES BELOW:

• CAREFULLY READ THE ASSEMBLY MANUAL IN ITS ENTIRETY. Failure to follow the safety rules identified on this page may result in serious personal injury.

• Carefully follow the AirScoot Assembly Manual Instructions included on this site and with the model. FAILURE TO PROPERLY ASSEMBLE THE MODEL MAY RESULT IN SERIOUS HARM.

• Read and carefully follow the manufacturer's instructions for your remote control.

• ALWAYS USE CAUTION. Make sure people around you know you are launching and flying a hobby model. ALWAYS FLY IN AN OPEN AREA (at least 50'x50' open area recommended for beginners).

• DO NOT FLY near an airport, airplane routes, high voltage wires; in temperatures below freezing; above or into people, vehicles, or buildings; in strong wind, bad weather or hazardous situations.

• DO NOT CONNECT THE BATTERY PACK to the Speed Controller before turing the Transmitter ON. DO NOT turn the Transmitter OFF until the Battery Pack has been disconnected from the Speed Controller.

• DO NOT TOUCH rotor blades while in motion and always keep model awary from your face when Battery Pack is connected.

Note: All information provided in this manual is subject to change without notice. AirScooter Corporation shall not be liable for errors herein or for consequential damages in connection with furnishing, performance or use of this material. U.S./INTERNATIONAL PATENTS PENDING. ©AirScooter Corporation 2002. All Rights Reserved.