On-line AirScoot Assembly Manual - Page 1
••• WARNING •••
DO NOT ATTEMPT TO FLY THE AIRSCOOT HOBBY MODEL WITHOUT READING THE COMPLETE AIRSCOOT SAFETY GUIDELINES (Follow Link to View) AND ALL SAFETY AND OPERATION MANUALS FOR ALL ACCESSORY PRODUCTS. WHILE THE AIRSCOOT'S DESIGN MAKES IT INTUITIVE TO FLY, A CLEAR UNDERSTANDING OF THE CONTROL SYSTEM AND PRACTICE TIME ARE REQUIRED FOR THE BEGINNER AND RECOMMENDED FOR THE EXPERT HOBBYIST.
STEP 1

Attach the Base Plate to the Landing Gear Assembly using (4) M3x16 SHCS and (4) M3 Lock Nuts, 2.5MM Hex Key and a 5.5MM Socket as shown.
STEP 2

Attach the Tail Fins to the Base Plate by inserting the Tail Fin Tubing into the existing socket (align fins vertically) and secure using a 2-5/16x1/2" SHCS and 2.0MM Hex Key. (Repeat process for remaining Tail Fin).
STEP 3

Attach the Upper and Lower Rotor Blades using (1) M3x22 SHCS and (1) M3 Lock Nut per blade and 2.5MM Hex Key and 5.5MM Socket until snug and loosen 1/2 turn.
Blades should NOT be tight.
STEP 4

Attach the Speed Control (#3), Rate Gyro (#4), Pitch (#2), and Roll (#1) Servos to the Receiver (not included) in the slot number indicated. See Appendix A to identify Control and Servo sources.
STEP 6

Insert the wrapped Receiver into the upper compartment of the Tail Mount Panel with the Antenna Wire exposed as shown.
STEP 5

Wrap the connected Receiver in the foam rubber as shown.

Note: All information provided in this manual is subject to change without notice. AirScooter Corporation shall not be liable for errors herein or for consequential damages in connection with furnishing, performance or use of this material. U.S./INTERNATIONAL PATENTS PENDING. ©AirScooter Corporation 2002. All Rights Reserved.