On-line AirScoot Assembly Manual - Page 2
••• WARNING •••
DO NOT ATTEMPT TO FLY THE AIRSCOOT HOBBY MODEL WITHOUT READING THE COMPLETE AIRSCOOT SAFETY GUIDELINES (Follow Link to View) AND ALL SAFETY AND OPERATION MANUALS FOR ALL ACCESSORY PRODUCTS. WHILE THE AIRSCOOT'S DESIGN MAKES IT INTUITIVE TO FLY, A CLEAR UNDERSTANDING OF THE CONTROL SYSTEM AND PRACTICE TIME ARE REQUIRED FOR THE BEGINNER AND RECOMMENDED FOR THE EXPERT HOBBYIST.
STEP 7

Feed the Receiver Antenna Wire through the center hole of the Tail Mount Panel.
STEP 8

Feed the Receiver Antenna Wire completely through the Antenna Protective Tubing (this step may require a firm piece of straight wire as a guide or pull).
STEP 9

Insert the Tubing into the Tail Mount Panel. Tubing should fit snug. Check the Antenna Wire from Receiver to the Tubing for any obstructions.
STEP 10

See Appendix B for Fairing Finishing Instructions before installing washers. Using a hobby adhesive, attach (4) Plastic Washers to the inside of the fairing cover over the existing holes. Once secure, insert (4) Rubber Grommets.
STEP 12

Attach the Fairing to the Landing Gear Assembly using (4) M2x10 SHCS, (4) M2 Washers and 1.5MM Hex Key.
STEP 11

Separate the rear portion of the Fairing Assembly and slide around the Main Rotor Assembly.
Note: All information provided in this manual is subject to change without notice. AirScooter Corporation shall not be liable for errors herein or for consequential damages in connection with furnishing, performance or use of this material. U.S./INTERNATIONAL PATENTS PENDING. ©AirScooter Corporation 2002. All Rights Reserved.