On-line AirScoot Assembly Manual - Page 3
••• WARNING •••
DO NOT ATTEMPT TO FLY THE AIRSCOOT HOBBY MODEL WITHOUT READING THE COMPLETE AIRSCOOT SAFETY GUIDELINES (Follow Link to View) AND ALL SAFETY AND OPERATION MANUALS FOR ALL ACCESSORY PRODUCTS. WHILE THE AIRSCOOT'S DESIGN MAKES IT INTUITIVE TO FLY, A CLEAR UNDERSTANDING OF THE CONTROL SYSTEM AND PRACTICE TIME ARE REQUIRED FOR THE BEGINNER AND RECOMMENDED FOR THE EXPERT HOBBYIST.
STEP 13

Attach a charged 10-Cell 2400mAh Battery Pack to the bottom of the Base Plate using (1) O-Ring Band as shown.
STEP 14

Connect the Battery Pack to the Speed Control. DO NOT make this connection unless the Transmitter is ON and immediate flight or checks (receiver channel connections, transmitter channel reverse, linkage adjustments, etc.) are planned. Always remove the blades when checking. Always disconnect immediately (with Transmitter ON) after flight or checks.
STEP 15

Slide the connected Battery Pack forward into the nose of the Fairing and secure with the remaining O-Ring Band. Note: The center of gravity of the AirScoot needs to be directly under the rotor shaft. Slide the Battery Pack until the proper center of gravity is achieved.
STEP 16

Assembly is complete. BEFORE ATTEMPTING TO FLY THE AIRSCOOT READ THE COMPLETE APPENDIX SECTION OF THE ASSEMBLY MANUAL.
Note: All information provided in this manual is subject to change without notice. AirScooter Corporation shall not be liable for errors herein or for consequential damages in connection with furnishing, performance or use of this material. U.S./INTERNATIONAL PATENTS PENDING. ©AirScooter Corporation 2002. All Rights Reserved.